USA Tel: (201) 880-0366 | info@britcycle.com | Fax (902) 542-7479 | Canadian Tel: (902) 542-7478
Helping keep British Motorcycles on the road for over 30 years - established 1977
Belt Buckles


Lapel Pins


85
Thanks Mark! The bike sold within 3 days of putting it on your site!

- Lisanne, Eugene, OR

New Arrivals & Just Catalogued Items

Hagon Twin and Mono Shocks now available for all makes, models and years. Special ordered for your needs and to your specifications.


March 2020 - CLUTCH PLATES, BSA PLUNGER A7/10
March 2020 - COIL, IGNITION, CURRENT LUCAS 1-1/2" OD (40MM) for clamp 391-54419974

391-45275 - 6V
391-45276 - 12V
March 2020 - Just in, a new shipment of Boyer Bransden electronic ignitions and power units.
March 2020 - 391-57162/ER REFLECTOR, ROUND, AMBER, BOLTON TYPE, RER25, REPLACEMENT
March 2020 - 391-31482 SWITCH, DIP, CLAMPON, BLACK, CURRENT LUCAS PRODUCTION
March 2020 - 82-8024/ER BATTERY CARRIER, PRE OIL-IN-FRAME, 12V, REPLACEMENT 1968 onwards. Powder coated gloss black.
March 2020 - BRACKETS, COIL - Triumph 650cc unit coil mounting bracket 1963-70. For the small coils 1.5" OD, not the large 1-7/8" OD.

82-6943 - Left hand only/drive side.
82-6944 - Right hand only/timing side.
March 2020 - 97-4031/ER STEERING HEAD BEARING, TAPER WITH SEAL, TRI/BSA, REPLACEMENT
March 2020 - 514-15 SEAT, UNIVERSAL TRIALS
March 2020 - 511-823119 SEAT, SOLO, RIGID, WITH SPRINGS, REPLACEMENT
March 2020 - TAILIGHT, VINCENT "STOP" TYPE, REPRODUCTION MILLER 394-01
March 2020 - Just in, Norton twin points seals. We have over ten thousand oilseals in stock for classic British cycle front forks, gearboxes, engines, primary cases, dynamos, magnetos, clutches, etc.
March 2020 - Just in, more performance valve spring kits from R/D Spring. We carry a wide range of US made R/D and Kibblewhite heavy duty valve spring kits in stock for classic Triumph, BSA, and Norton in both conventional coil spring and beehive spring, with steel, alloy and titanium collars, for use with performance cams.
March 2020 - 391-553267/ER HEADLIGHT RIM, INNER NACELLE, CHROME, REPLACEMENT
March 2020 - Just in - 37-3460/SS COVER, 8" FRONT HUB, 9" DIAMETER, STAINLESS
Feb 2020 - GASKET SET, TRIUMPH 500 UNIT CONSTRUCTION, PERFORMANCE, NO HEAD GASKET 433-06/A
Feb 2020 - 623-02/A SEALING WASHER, COPPER/RUBBER, 1/4BSP FUELTAP - Many prefer this to the bonded 70-7351 sealing washer or the original fibre sealing washers. All types of sealing washers should be used with a thin steel 83-0002 washer against the jam nut, also in stock.
Feb 2020 - 99-3733/A TAPER BEARING CONVERSION SET, STEERING HEAD - Taper bearing set for Triumph steering heads on the following models: 1956 onward Triumph preunit 500, all 1956 through 1970 Triumph 650, 1967 onwards Triumph 500 twins except TR5T. Replaces cups, cones and loose balls.
Feb 2020 - TRIUMPH HIGH PERFORMANCE ROCKERBOX GASKETS - “CovSeal” stainless steel reinforced – will not creep. 1963-70 TRIUMPH 650, 1971 ON TRIUMPH 650/750.

We also have CovSeal rockerbox gaskets for Tri/BSA triples, Triumph unit 500 twins, and Triumph preunit 500/650 as well as tons of other high quality gaskets and gasket sets for classic British cycles.
Feb 2020 - TRIUMPH/BSA UNIT 250 PISTONS WITH CLIPS AND PINS 441-16945/ER - FINALLY, THE FIRST NEW PRODUCTION BATCH OF UNIT 250 PISTONS IN YEARS, MADE BY JCC, IN STD AND ALL OVERSIZES. FULL STOCK OF QUALITY RING SETS IN ALL SIZES ON HAND TOO.
Feb 2020 - Just in, new batch of high quality UK made Venhill low friction cables.
Feb 2020 - 221-38/B CARB SYNCHRONIZER - No more guesswork! Sync your twin carbs precisely.
Feb 2020 - JUST IN: a new batch of our 221-30 thread gauge tools, a must for anyone working on British cycles. The 11th commandment is “Know thy thread pitch!!”
Feb 2020 -  345 SERIES - COLOUR CODED WIRE – 100 FOOT ROLLS
Feb 2020 - 335-06 BATTERY, 6N113A, LATE STYLE 6VOLT
Feb 2020 - 233-09 THREEBOND LIQUID GASKETMAKER, 3.5 OZ
Feb 2020 - Just in, lots of VALVE ADJUSTER SETS, "MUSHROOM" TYPE.

71-3358/A -- LONG, Set of six for Triumph triples from serial # T150V 04571 on, with short valves.

70-1513/B -- Set of four for Triumph T120/T140 Unit construction and BSA A7/A10 with CEI thread.

06-7546/B -- Commando.

68-0155/A -- Or sub Triumph type 70-1513/B, which will work fine. Slightly different lengths.

70-3223/B -- Triumph 350/500 twins and Cub

70-8783/B -- SHORT, For Triumph triples with long valves.

71-7045/A -- 24 TPI, Later Triumph twins.
Feb 2020 - Justin, another batch of low resistance Dyno Dave heavy duty starter wire sets, huge improvement for any Norton 850 Mk3ES, but an absolute necessity when installing a heavy duty starter motor in these motorcycles.

Remember, we distribute all Dyno Dave products including his heavy duty high powered electric starters, part number 06-4871/B with dual sealed bearings and 4 brush construction, for maximum torque and best starts.

There are some copies out there, but we only sell the genuine article, designed and hand assembled in the USA by the designer, Dyno Dave himself, and offered by us with his lifetime warranty against defects in manufacture or workmanship.

Get the Real Thing!
Feb 2020 - New shipment from PODtronics:

332-02/B REGULATOR, 6VOLT DYNAMO, ELECTRONIC, NEGATIVE GROUND

332-104/J POWER CONTROL UNIT, SINGLE PHASE, 200WATT RATING WITH CAPACITOR

332-105/E POWER CONTROL UNIT, THREE PHASE
Feb 2020 - New shipment of Barnett clutch plates and clutch springs!
February 2020 - 571-30/C/A CABLE, CLUTCH, 2'6", MAGNETIC WITH SPADE, AMOURED - Due to current “armoured” replacement speedo and tach cables now having the protective metal covering where fitted looking nothing like original, Britcycle has added exact replicas of the original SMITHS instrument cables to our range for restorers and those who like highest quality products.
January 2020 - JUST IN TO OUR USA WAREHOUSE, MORE US MADE KIBBLEWHITE HEAVY DUTY VALVE TRAIN COMPONENTS FOR TRIUMPH, BSA, AND NORTON
January 2020 - We're selling our MINIBIKE, BSA, 50CC, 10" WHEELS